Filter
Top Products
Data modules and asynchronous data units
555-233-116
80 Issue 4 October 2002
Exiting command mode on the 7400B
After configuring the 7400B, exit command mode, and put the data module back
online.
1. Enter O (capital O).
Configuring the 7400C HSL (high-
speed link) data module
Figure 15 shows the front and rear of a 7400C synchronous data module.
Figure 15. 7400C data module (high speed link)
Setting the data speed for the 7400C
Proceed as follows.
1. From the HOME screen, press the NEXT/NO button until SET DATA
OPTS? appears. Then press the ENTER/YES button.
SET DATA OPTS?
DATA NEXT/NO BACK ENTER/YES
● ❍ ❍ ➜ ●
Push the button indicated by the arrow (➜)