Filter
Top Products
External modems
555-233-116
100 Issue 4 October 2002
Paradyne COMSPHERE 3715
You configure COMSPHERE 3715 modems using the Hayes-compatible AT
commands common to many modems. For instructions on how to physically
connect the modem and enter the commands listed in the instructions below, see
the documentation that came with the modem.
Configuring the 3715 for CMS
The instructions below set up the modem for use in a Call Management System
(other configurations may work as well).
1. From the command line prompt of your terminal emulation software or
terminal, enter at&f.
This loads factory default configuration options into active memory. If all is
well, the modem replies OK.
2. Enter at%b9600.
This sets the data speed to 9600 kbps. If all is well, the modem replies OK.
3. Enter atq1&r0&S1\d1&w0.
This disables result codes, sets the RTS (Request To Send), DSR (Data
Set Ready), CTS (Clear To Send) signals action to standard RS-232
operation, and saves the changes to profile 0. If all is well, the modem
replies OK.
Configuring the 3715 for modem pooling
The instructions below set up the modem for use in a modem pool (other
configurations may work as well).
1. From the command line prompt of your terminal emulation software or
terminal, enter at &f.
This loads factory default configuration options into active memory. If all is
well, the modem replies OK.
2. Enter at m0 x7 y0 &s1 /d1.
If all is well, the modem replies OK.
3. Enter at e0 v0 c2=128 s7=60 f10=100 &w0 &y0.
If all is well, the modem replies OK.