Filter
Top Products
External modems
555-233-116
108 Issue 4 October 2002
Exiting the dial line menu
Skip over the remaining menu headings. Proceed as follows.
1. Press F1 to select Nxt.
The V32bis Automode (Enable) menu heading appears.
2. Press F1 to select Nxt.
The V32bis Autorate (Enable) menu heading appears.
3. Press F1 to select Nxt.
The Dial Tx Level (Permissv (-9)) menu heading appears.
4. Press F1 to select Nxt.
The V22b Guard Tone (Disable) menu heading appears.
5. Press F1 to select Nxt.
The V32bis Train (Long) menu heading appears.
6. Press F1 to select End.
The Edit StrapGroup > prompt appears.
Saving the new configuration
You must save the configuration changes you have made before you can use
them.
1. From the Edit StrapGroup > prompt, press the single up-arrow button
once.
The Choose Function, Edit, and Save menu headings appear.
2. Press F3 to select Save.
The Save EditArea to > prompt appears.
3. Press F1 to select Active(Saved).
The Command Complete message appears.
4. Press the single up-arrow button again.
The Save EditArea to > prompt appears.
5. Press the right-arrow button once to select Customer 1.
6. Press F1 to save changes to the Customer 1 storage area.
The Command Complete message appears.
7. Press the double up-arrow button once.
The Idle:9600 and Status Configure messages appear. When you power
off the modem, it should return to this state.