Filter
Top Products
Installing and administering the terminal server
Issue 4 October 2002
129555-233-116
5. Fill in the following fields. Leave the default settings for the other fields.
■ Speed: 19200
■ Monitor DSR: Yes
■ Monitor DCD: No
■ Name: port number or other descriptive name
■ Terminal type: undef
■ CLI/Menu: CLI
■ Reset Term: No
■ Flow ctrl: Both
NOTE:
This is very important! If the link goes down between the
terminal server and the adjunct, the terminal server buffers the
data and notifies the switch. Once the terminal server buffer
fills up, the switch buffers the data. The switch raises an alarm
once the switch buffer is full.
■ IP addresses: leave blank
■ Mask: leave blank
■ Access: Local
■ Authentication: None
■ Mode: Telnet
■ Connection: Initiated
** Administrator ** PORT SETUP MENU Terminal: 2
Hardware Flow ctrl Keys
Speed [19200 ] Flow ctrl [Hardware] Hot [^]] Intr [^C]
Parity [None] Input Flow [Enabled ] Quit [^@] Kill [^U]
Bit [8] Output Flow [Enabled ] Del [^@] Sess [^@]
Stop [1 ] Echo [^@]
Break [Disabled] IP Addresses
Monitor DSR [Yes ] Src [ ] Mask [ ]
Monitor DCD [No ] Dst [ ]
User Options Access
Name [port 2 ] Keepalive [No ] Access [Local ]
Terminal type [undef ] Rlogin/Telnet [Telnet] Authentication [None ]
TERM [ ] Debug options [No ] Mode [Telnet ]
Video pages [0] Map CR to CR LF [No ] Connection [initiated]
CLI/Menu [CLI] Hex data [No ] Host [ ]
Reset Term [No ] Secure [No ] Remote Port [9001 ]
MOTD [No ] Local Port [10002]
________________________________________________________________________________