Filter
Top Products
MS-DOS Boot Error Message
The following error messages may be displayed at system boot time and
can be caused by an incorrect board configuration.
SRAM MEMORY ERROR (Indicates faulty memory or memory not found.)
BIOS RESET ERROR (Indicates BIOS failed to initialize correctly.)
The following error messages may be displayed at system boot time and
can be caused by a hardware problem.
FEPOS CODE MOVE ERROR (Indicates error when loading the on-board operating system.)
FEPOS INITIALIZATION ERROR (Indicates the on-board system failed to initialize.)
In response to these error messages, do the following.
■
■
■
■
■
Check that the board parameters match the parameters specified by the
IPC16CNF
program.
Try to reload the
IPC16DOS.SYS
driver.
If the system still fails, recopy the driver from the “Intelligent Ports
Card (IPC-1600) MS-DOS Device Drivers and Diagnostics, Version 1.0”
diskette to the hard disk drive and try to reload the driver.
Run the diagnostics.
Call the AT&T HOTLINE at 1-800-922-0354 for help, as necessary.
7-2 IPC-1600 USER’S GUIDE