Filter
Top Products
Installation Procedures
Specify Shared or Board-Unique Hardware
Interrupt Assignment
The installation process then asks you to specify how hardware interrupts
are to be assigned.
The IPC-1600, Intelligent Ports Card - Version 1.0
package allows the ports boards to be configured to all use the same
interrupt (shared) or for each board to be configured to a different
interrupt. If interrupts are shared, a maximum of 7 ports boards
may be installed. If each board is configured to a different interrupt,
then at most 5 can be installed.
Do you want to share interrupts among all boards? (y or n)
If you specify to share an interrupt level among all boards, you are then
asked to select the interrupt to be used by all IPC-1600 boards as follows.
The device driver used for IPC-1600, Intelligent Ports Card
- Version 1.0 allows all the boards installed to be strapped
to the same interrupt. Please select the interrupt that
will be used from the list below. The available
interrupt(s) for the ports boards are:
IRQ 3
IRQ 5
IRQ 10 (default)
IRQ 11
IRQ 12
Type the interrupt number and strike the ENTER key or type
Q to cancel installation. Striking the ENTER alone will
select the default.
Enter Interrupt:
UNIX SYSTEM DEVICE DRIVER INSTALLATION 3-7