Filter
Top Products
DS1 Switch Settings—Controller Memory Starting Address
The following table shows the switch settings for some of the possible
controller memory starting addresses.
Note:
The IPC-1600 UNIX system driver installation scripts support
only selected starting controller memory addresses as
standard. The installation script displays the appropriate
standard addresses dependent on the available system
configuration resources. For the a typical AT&T 6386E Work
Group System, the installation script identifies the following
available controller memory addresses.
080000h
180000h
300000h
480000h
600000h
780000h
900000h
A80000h
C00000h
D80000h
F00000h
090000h
200000h
380000h
500000h
680000h
800000h
980000h
B00000h
C80000h
E00000h
F80000h
100000h
280000h
400000h
580000h
700000h
880000h
A00000h
B80000h
D00000h
E80000h
The recommended controller memory address range is
080000h through 0BFFFFh for the following machines:
■ AT&T 6386E Work Group System
■ AT&T 6386/25 Work Group System
■ AT&T 6386E/33 Work Group System
■ AT&T 6386E/33 Work Group System Model S.
The available controller memory address range is 080000h
through F80000h. However, the installation software supports
only selected starting addresses within this range as shown in the
previous listing.
A-4 IPC-1600 USER’S GUIDE