Filter
Top Products
Installation Procedure
Install the Hardware
Refer to Chapter 4, “Hardware Installation,” and follow the instructions
for the installation of the board. Ignore any instructions in Chapter 4
involving the DS1 and DS2 DIP switches, since they have already been done
in this procedure.
Load the Software
Power up the system [AT&T Work Group System (WGC) computer] to
boot native MS-DOS (Version 3.0 or later) from either the floppy diskette or
the system disk drive.
Insert the MS-DOS device driver diskette into the appropriate diskette
drive and close the diskette drive door.
Use the MS-DOS COPY command to copy all files from the diskette to
the system disk. It is recommended that you create a separate directory for
the IPC-1600 files as shown in the following examples. Note that system
prompts are machine dependent.
As shown in the following screen display, first, shift from the “A” drive to
the “C” (system disk) drive and create a directory named IPC as follows.
A:
C:
C:
$ C:
$ mkdir ipc
$
2-4 IPC-1600 USER’S GUIDE