Filter
Top Products
Installation Procedure
Now, change directory (cd) to IPC and copy the files on the diskette in the
“A” drive or in the “B” drive to the system disk drive as follows. The
example uses the “A” diskette drive; the system disk is the “C” drive.
Change directory to an optional separate directory to
contain the IPC-1600 software.
C: $ cd ipc
Copy the files from the “A” drive to the “C” drive
C:\IPC $ copy a:*.* /v
A:IPC16CNF.EXE
A:IPC16DOS.SYS
A:IPC16DIA.COM
3 File(s) copied
C:\IPC $
Remove the “Intelligent Ports Card (IPC-1600) MS-DOS Device Drivers
and Dagnostics, Version 1.0” diskette from the diskette drive and properly
store the diskette.
There are two files on the “Intelligent Ports Card (IPC-1600) MS-DOS
Device Drivers and Diagnostics, Version 1.0” diskette concerned with the
installation of the MS-DOS driver:
IPC16CNF.EXE
Use this command to configure the Intelligent Ports
Card driver characteristics.
IPC16DOS.SYS
MS-DOS device driver for the IPC-1600.
The IPC16DIA.COM file provided on the MS-DOS diskette is the IPC-1600
diagnostics. Diagnostics are described in Chapter 7.
MS-DOS DEVICE DRIVER INSTALLATION 2-5