Filter
Top Products
Introduction
The IPC-1600 board can be installed in any 16-bit or 32-bit bus expansion
slot in following machines:
■ AT&T 6386E Work Group System
■ AT&T 6386/25 Work Group System
■ AT&T 6386E/33 Work Group System
■ AT&T 6386E/33 Work Group System Model S.
Refer to the appropriate “User's Guide” supplied with your machine for
board installation instructions. This chapter guides you through the process of
installing the appropriate hardware. However, refer to the documentation that
came with your system for instructions on how to install/remove a bus
expansion slot board.
Also, be sure to refer to the notes you were instructed to make when you
were installing the software (Chapters 2 and 3). You will need these notes to
set the various switch settings on the IPC-1600 board.
Although this chapter does not explicitly cover removing a board or
installing an additional board or boards at a later time, the instructions
provided here can help you do future hardware changes.
Note:
Each IPC-1600 board in the system must be assigned a unique
I/O address, a controller memory address range, and a
hardware Interrupt ReQuest (IRQ) level which do not conflict
with any other board types in the system. All IPC-1600
boards in a system must be set up to support ONE of the
following conditions:
1.
2.
3.
4.
Share controller memory and share one IRQ level
(preferred condition)
Share controller memory and have unique IRQ levels
Unique controller memory address assignments and
share one IRQ level
Unique controller memory address assignments and
unique IRQ levels.
HARDWARE INSTALLATION 4-1