Filter
Top Products
General Installation Procedures
Power up the AT&T WGS computer, making sure that no diskette is in
the diskette drive(s) during the boot phase. Wait until the UNIX system is
ready, and then log in using either “root” or the privileged access user
administration login you have been assigned.
Insert the “Intelligent Ports Card (IPC-1600) UNIX System V/386 Device
Drivers, Version 1.0” diskette into the appropriate diskette drive (5.25-inch or
3.5-inch drive) and close the diskette drive door.
At the UNIX system prompt, enter the following:
installpkg
Press the ENTER key. This invokes the UNIX system software package
installation program, which allows you to install the IPC-1600 UNIX system
serial I/O driver.
More information about using the installpkg command is given in the
UNIX System V/386 Operations/System Administration Guide.
Note 1: Each IPC-1600 board in the system must be assigned a
unique I/O address, a controller memory address range, and
a hardware Interrupt ReQuest (IRQ) level which do not
conflict with any other board types in the system. All
IPC-1600 boards in a system must be set up to support ONE
of the following conditions:
1.
2.
3.
4.
Share controller memory and share one IRQ level
(preferred condition)
Share controller memory and have unique IRQ
levels
Unique controller memory address assignments and
share one IRQ level
Unique controller memory address assignments and
unique IRQ levels.
Note 2:
The use of 080000h or 090000h as the controller memory
starting address requires that the base memory above 512KB
(512KB to 640KB) be disabled.
3-4 IPC-1600 USER’S GUIDE