Filter
Top Products
Connect the Ribbon Cables to the
IPC-1600
Route the ribbon cables from the 16-Ports Fanout module to the host
computer. Thread the ends of the ribbon cables through the board slot
opening in the host computer and connect them to the IPC-1600 board. The
connectors are keyed for proper alignment with the 80-pin headers on the
board. Observe the port markings on the front of the 16-Ports Fanout module
to insure correct port numbering on the fanout module. Connect the ribbon
cable for ports 9 through 16 to header P3. Connect the ribbon cable for
ports 1 through 8 to header P4. Refer to Appendix B, “Serial Input/Output
Device Interface,” for more information on these connections. Make sure that
the retaining clips are properly secured.
HARDWARE INSTALLATION 4-5