Filter
Top Products
Installation Procedures
Assigning Board-Unique Starting Controller
Memory Address
If you specified board-unique controller memory assignment, the system
now displays a list of available starting controller memory addresses and
prompts you to enter the address to be assigned to the board. The IPC-1600
comes from the factory with the controller memory address range set to
080000h—08FFFFh; if 080000h—08FFFFh is already assigned, the first
available starting controller memory address in the displayed list appears as
the default. The hardware controller memory address range(s) will be set to
match the software assignment(s) later in Chapter 4. The following screen
shows the typical display.
Please enter the following system configuration information
for IPC-1600 Board 1. The available starting controller
memory addresses for the IPC-1600 Board 1 are:
Starting Memory address(s):
080000
180000
300000
480000
600000
780000
900000
A80000
C00000
D80000
F00000
(default) 090000
200000
380000
500000
680000
800000
980000
B00000
C80000
E00000
F80000
100000
280000
400000
580000
700000
880000
A00000
B80000
D00000
E80000
Type the starting controller memory address and strike the
ENTER key or type Q to cancel installation. Striking the ENTER alone
will select the default:
Either press the ENTER key (to enter the default) or type in the name of
the controller memory address that you wish to assign and then press
ENTER.
UNIX SYSTEM DEVICE DRIVER INSTALLATION 3-13