Filter
Top Products
Installation Procedures
If you specify to share controller memory among all boards, you are then
asked to select the controller memory starting address to be used by all
IPC-1600 boards as follows. The IPC-1600 comes from the factory with the
controller memory address range set to 080000h-08FFFFh. Remember to
select a controller memory address range which does not conflict with other
board types in the system.
The device driver used for IPC-1600, Intelligent Ports Card
- Version 1.0 allows all the boards installed be strapped
to the same controller memory address. Please select the
controller memory address that will be used from the list
below. The available controller memory address(es) for the
ports boards are:
Starting Memory address(s):
080000
180000
300000
480000
600000
780000
900000
A80000
C00000
D80000
F00000
(default)
090000
200000
380000
500000
680000
800000
980000
B00000
C80000
E00000
F80000
100000
280000
400000
580000
700000
880000
A00000
B80000
D00000
E80000
Type the starting controller memory address and strike the
ENTER key or type Q to cancel installation. Striking the ENTER alone
will select the default:
UNIX SYSTEM DEVICE DRIVER INSTALLATION 3-9