3Com Telephone Local User Interface Menus 159
Advanced Settings Displays the following menu options:
Set NCP MAC Address – Not used in a VCX network.
Show EEPROM Contents – Lets you scroll through the
locations in the memory of the telephone. The information is
presented in hexadecimal format and can be properly
interpreted only by a 3Com service person.
Set EEPROM - Default – Restores the phone to default
settings by clearing these configured settings:
■ IP Information – Phone IP, Subnet Mask, Gateway IP,
and the NCP IP return to 255.255.255.255.
■ NCP MAC address – The NCP MAC address returns to
ffff:ffff:ffff.
■ SIP Parameters – All SIP specific parameters will be set to
default 0xffff (data parameters) or 255.255.255.255 for
IP addresses.
NOTE: If you select this option you are prompted to verify
your action before the system clears the EEPROM.
Force Operational SW Upgrade – Forces the phone to
download the latest operational software from the NCP.
Hardware Reset – Resets the phone. You can perform the
same task by disconnecting, then reconnecting, power to the
phone.
Ping H3/IP – This option is not used in VCX networks.
Test - LED & LCD – Turns on all LEDs for 5 seconds and tests
every pixel on the Display Panel.
Test - Buttons – Puts the telephone in the button test state.
Press any telephone button to see a description of the
button’s function.
VCX Configuration Displays the following menu options:
Set VLAN Configuration – Used to enable or disable VLAN
configuration.
Enable – You are prompted to enter the VLAN ID. A valid
VLAN ID is in the range of 0 through 4095. Press the
pound key (#) to store it in memory.
Disable - VLANs are disabled. This is the default.
Diagnostics Allows you to display network statistics for the phone. This
option requires a password. The default password is the
phone extension.
Table 21 Manager’s Telephone LUI Menu Items (continued)
Menu Option Description
