Filter
Top Products
Chapter 9 Quality of Service (QoS)
FMG3024-D10A / FMG3025-D10A Series User’s Guide
128
DSCP Mark This field is available only when you select the Ether Type check box in
Criteria Configuration-Basic section.
If you select Mark, enter a DSCP value with which the Device replaces the
DSCP field in the packets.
If you select Unchange, the Device keep the DSCP field in the packets.
802.1p Mark Select a priority level with which the Device replaces the IEEE 802.1p priority
field in the packets.
If you select Unchange, the Device keep the 802.1p priority field in the
packets.
To Queue Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface Select whether the traffic class comes from the LAN.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address,
IP address, DHCP options, DSCP value or the protocol type.
If you select 8021Q, you can configure an 802.1p priority level and VLAN ID in
the Others section.
Source
MAC Address Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a
packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC
address should match. Enter “0“ for the bit(s) of the matched traffic’s MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a
packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
IP Address Select the check box and enter the source IP address in dotted decimal
notation. A blank source IP address means any source IP address.
IP Subnet Mask Enter the source subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check box and
enter the port number(s) of the source.
Exclude Select this option to exclude the packets that match the specified criteria from
this classifier.
Destination
MAC Address Select the check box and enter the destination MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a
packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC
address should match. Enter “0“ for the bit(s) of the matched traffic’s MAC
address, which can be of any hexadecimal character(s). For example, if you set
the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a
packet with a MAC address of 00:13:49:12:34:56 matches this criteria.
Table 27 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION