ZyXEL Communications FMG3025-D10A IP Phone User Manual


 
Chapter 9 Quality of Service (QoS)
FMG3024-D10A / FMG3025-D10A Series User’s Guide
123
The following table describes the labels in this screen.
9.3 The Queue Setup Screen
Use this screen to configure QoS queue assignment. Click Network Setting > QoS > Queue
Setup to open the screen as shown next.
Table 23 Network Setting > QoS > General
LABEL DESCRIPTION
Active QoS Select the check box to turn on QoS to improve your network performance.
You can give priority to traffic that the Device forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly.
Similarly, give low priority to many large file downloads so that they do not reduce
the quality of other applications.
WAN Managed
Upstream
Bandwidth
Enter the amount of bandwidth for the WAN interface that you want to allocate
using QoS.
The recommendation is to set this speed to match the interface’s actual
transmission speed. For example, set the WAN interface speed to 1000 kbps if
your Internet connection has an upstream transmission speed of 1 Mbps.
Setting this number higher than the interface’s actual transmission speed will stop
lower priority traffic from being sent if higher priority traffic uses all of the actual
bandwidth.
If you set this number lower than the interface’s actual transmission speed, the
Device will not use some of the interface’s available bandwidth.
Leave this field blank to have the Device set this value automatically.
Traffic priority
will be
automatically
assigned by
These fields are ignored if upstream traffic matches a class you configured in the
Class Setup screen.
If you select Ethernet Priority, IP Precedence or Packet Length and traffic
does not match a class configured in the Class Setup screen, the Device assigns
priority to unmatched traffic based on the IEEE 802.1p priority level, IP
precedence or packet length.
See Section 9.6.1 on page 131 for more information.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.