Filter
Top Products
+
You can also transfer data from units that are not
8900/9000
Series using a RAM card or via the PC-Link
mode. See p. 241 and p. 251, respectively.
Transferring
To transfer data between two units, you can also select
data to/from
an application on the RAM card to transfer data either to
a RAM card
or from.
application
Simply press
(6%6)
to select the card memory in the
application in which you want to send or receive the data,
then press
[GET)
or
[SEND)
, or open the
PERIPHERALS
menu.
To receive single entries using
[m]
or
Filer
folders in
the card memory by either infrared or cable transfer, first
select the card memory using SET DATA DESTINATION
in the
PERIPHERALS
menu on the receiving unit.
Exchanging Information with a Personal
Computer
Using SHARP’s optional Organizer Link software and
cable package or certain third party software packages,
you can exchange data with a personal computer. Certain
software will allow you to exchange data with a personal
computer via the unit’s infrared port using the optional
CE-IR2 wireless interface. This makes it possible, for
example, to use the unit when outside your home or
office, then later transfer the data you have entered on
the unit to your desktop computer.
To set-up the unit for use with the Organizer Link:
1.
Make sure the unit is turned off.
q
:
2.
l
For infrared transfer, set up the unit with the CE-IR2
wireless interface. (See the CE-IR2 manual for details.)
l
For a cable transfer, connect the Organizer Link cable
to the unit’s
15-pin
cable jack. (See the unit Link
manual for details.)
251