Filter
Top Products
45
Chapter 3 Advanced Operation
Setting the Key Lock
You can lock all the buttons and the navigator key of the cordless handset.
Only incoming calls are accepted until the key lock is canceled.
Make sure that the cordless handset is in the
standby mode.
Press and hold (FUNCTION) until a short beep
sounds.
To cancel the key lock, press and hold (FUNCTION) until a short beep
sounds.
• “Key lock” will disappear.
Handset
Key lock [1]
FLASH Button
Pressing (FLASH) allows you to use special features of your host PBX such
as transferring an extension call or accessing special telephone services
(optional) such as call waiting.
Selecting the flash time for each line
The flash time depends on your telephone exchange or host PBX. You can
select from flash times: “700, 600, 400, 300, 250, 110, 100 or 90 ms
(milliseconds)”. Your phone comes from the factory set to “700 ms”.
Make sure that the base unit is in the standby mode.
Base Unit
Base Unit
Handset
5
Press (ENTER).
• A beep sounds.
• To return to the standby mode,
press (EXIT).
1
Press (FUNCTION).
2
Press or until the arrow
points to “Dial setting”, and
press H.
3
Press or until the arrow
points to “Set flash time”,
and press H.
• The current settings are displayed.
4
Select the desired time by
pressing or for each line.
To move to another line, press
H or I.
• If you are connected via a PBX, a
longer flash time may be necessary to
use PBX functions (transferring a call
etc.). Consult your PBX installer for
the correct setting.
Flash time
L1 L2 L3 L4
700m700m700m700m