Filter
Top Products
20
4
Select AM or PM by pressing .
5
Press (ENTER).
• A beep sounds. The clock starts
working.
• To return to the standby mode,
press
(EXIT).
1
Press (FUNCTION).
2
Press or until the arrow
points to “Date and time”,
and press H.
3
#Enter the year, and month and
day using 4-digit numbers.
Ex. To set Apr. 7, 2000, enter
“2000”and “0407”.
$Enter the time (hour and
minute) using a 4-digit
number.
Ex. To set 9:30, enter “0930”.
Date and Time Adjustment
Make sure that the base unit is in the standby mode.
Base Unit
For Caller ID service users (p. 38)
• The Caller ID information will re-set the clock after the first ring if the adjusted
time is incorrect. However, if the time has not previously been set, the Caller
ID information will not adjust the clock.
• The Caller ID information will automatically adjust the clock for daylight saving
time.
If a power failure occurs, the adjusted date/time will be retained for at least 20
minutes with the backup battery fully charged (p. 12). Readjust if the date/time is
flashing on the display.
• When entering the time in step 3, you
cannot enter numbers greater than 12.
Do not use military time. (To set
13:00 hours, enter “0100” and select
“PM” by pressing .)
Date:2000.01.01
Time:12:00 AM
∨
=PM ENTER=Save
Date:2000.04.07
Time:09:30 AM
∨
=PM ENTER=Save
9:30PM APR. 7
• If you enter a wrong number, press
I or H to move the cursor to the
incorrect number. Enter the correct
number.
Voice Date/Time Stamp: After each message playback, a synthesized voice will
announce the date and time that each message was recorded (p. 67, 70, 78).
Date:2000.04.07
Time:09:30 PM
∨
=AM ENTER=Save
• If 3 beeps sound, the setting is not
correct. Start again from step 3.
Programmable Settings