Filter
Top Products
21
Chapter 1
Preparation
4
Select “Puls” (Pulse) or “Tone”
by pressing or for each
line. To move to another line,
press H or I.
5
Press (ENTER).
• A beep sounds.
• To return to the standby mode,
press (EXIT).
1
Press (FUNCTION).
2
Press or until the arrow
points to “Dial setting”, and
press H.
3
While “Set dial mode” is at
the arrow, press H.
• The current settings are displayed.
Selecting the Dialing Mode
If your lines have touch tone service, set to “Tone”. If rotary or pulse
service is used, set to “Pulse”. Select the mode for each line. Your phone
comes from the factory set to “Tone”.
Make sure that the base unit is in the standby mode.
Base Unit
Selecting the Ringer Volume
You can set the base unit and cordless handset ringer volumes to HIGH,
LOW or OFF. If set to OFF, the base unit/handset will not ring. Your phone
comes from the factory set to HIGH. Programming must be carried out
separately for the base unit and cordless handset(s).
Make sure that the base unit/cordless handset is in the standby mode.
Base Unit
Handset
To turn the ringer ON, press in
step 4.
• The ringer will sound at the LOW
level.
1
Press (FUNCTION).
2
Press or until the arrow
points to “Ringer setting”,
and press H.
3
While “Ringer volume” is at
the arrow, press H.
• The current volume is displayed .
4
Press to increase or press
to decrease the volume.
• Each time you press or ,
the volume will change and ring.
• To turn the ringer OFF, press
and hold until a beep sounds.
LOW
HIGH
OFF
Ringer volume
Low
❚❚❚❚❚❚❚
High
∨∧
Low
❚❚
High
Ringer off
Dial mode
L1 L2 L3 L4
ToneToneToneTone