Filter
Top Products
2.4 Installation of Optional Cards and Unit
General Installation
85
3. If you do not cut the wire of the J200 in Pay Tone Card, the detected mode is 16 KHz. If
you cut the wire of the J200 in Pay Tone Card (Open Mode), the detected mode is 12 KHz.
4. After installing the Pay Tone Card, if you hear a noise of the pay-tone signal, cut the option
Jumper Wires, OPJPA through OPJPH, in the CO Card.
KX-TD816: OPJPA through OPJPD corresponds to outside line (CO) 01 through 04
respectively.
KX-TD1232: OPJPA through OPJPH corresponds to outside line (CO) 01 through 08
respectively.
<Example>
– When you install the Pay Tone Card A, you will detect the pay-tone signal from outside
line (CO) 01 through 04, and cut the corresponding option Jumper Wires, if needed.
– When you install the Pay Tone Card B, you will detect the pay-tone signal from outside
line (CO) 05 through 08, and cut the corresponding option Jumper Wires, if needed.
5. Put the inside cover back on the main unit and secure the screws.
J200
J200
CO07,08
CO05,06
CO03,04
CO01,02
OPJPB OPJPC OPJPD OPJPE OPJPF OPJPG OPJPH
OPJPA
B
A
Cut here
CO Line Card
Inside Cover
Pay Tone Card
CO Line Card
OPJPA – H
KX-TD1232