Filter
Top Products
5.2 Wireless System Installation
DECT Installation
173
d) Press (Talk).
• The result is recorded.
Display example: LOG NO.?(0-9) 0
STORED
Note
• The results of measurement for the 24 slots on the channel are saved each time a channel is
set. If the same channel is set, the new results override the previous ones. Therefore, a
measurement of 10 channels 24 slots in total can be made.
• If correct results cannot be obtained (e.g. there are many error counters), change the
allocation of the Cell Station and repeat the site survey to select the best location.
• When a slot is synchronised in step 2 ("SYNC" is displayed), the other slots in the same
channel show "OTHER".
• Please do not use several PSs for the test simultaneously. This may cause interference
problems, so that the test may not executed properly.
Referring to the recorded Radio Signal Test result
1. Set the PS Power Switch to ON while pressing (Talk), (Recall) and
at the same time.
Display: FUNCTION<0-4>
2. Press .
Display: RESULT OF SCAN
LOG NO.?(0-9)
3. Enter the desired log number (0 through 9).
Display example: RESULT OF SCAN
LOG NO.?(0-9) 0
4. Press (Talk).
• The results of channel 0 and slot 0 will be displayed.
Display example: CH0 SLOT:00 SYNC
L:12 0000/0100
• To go to another slot, scroll by pressing (Next) or (Previous).
To go to another channel, enter the channel number (0 through 9).