Filter
Top Products
2.3 Connection
General Installation
63
2.3.8 Printer and PC Connection
A user-supplied printer or personal computer (PC) can be connected to the system. These are
used to print out or refer to the Station Message Detail Recording (SMDR) call records and
system programming data.
Connect the printer cable or the PC cable to the Serial Interface (RS-232C) connector. The
cable must be shielded and the maximum length is 2 m.
Note
The KX-TD1232 is illustrated as the main unit.
Arrange cables so that the printer will be connected to the system as shown in the chart on the
following page.
The pin configuration of Serial Interface (RS-232C) Connector is as follows:
Pin
No.
Signal Name Circuit Type
EIA CCITT
1
2
FG
SD (TXD)
Frame Ground
Transmitted Data
AA
BA
101
103
3
4
RD (RXD)
RS (RTS)
Received Data
Request To Send
BB
CA
104
105
5
6
CS (CTS)
DR (DSR)
Clear To Send
Data Set Ready
CB
CC
106
107
7
8
SG
CD (DCD)
Signal Ground
Data Carrier
Detect
AB
CF
102
109
20 ER (DTR) Data Terminal
Ready
CD 108.2
Serial Interface
(RS-232C) (25-pin)
Printer or Computer