Filter
Top Products
5.2 Wireless System Installation
160 DECT Installation
6. Wireless Extension Connection
Use a Cell Station Cord (4-conductor wiring - included) and 4-pin plug (included) to
connect the cell station line. There are 2 plugs for the KX-TD144 and 6 plugs for the KX-
TD146 to connect the Cell Stations.
Maximum length of the cable: AWG 24 (0.6 mm in diameter): Under 1 km
a) Insert the wires of the 4-conductor wiring cord into the holes in the plug to connect pins
"D1", "D2", "V1" and "V2".
D1: Data 1 V1: Voltage +
D2: Data 2 V2: Voltage –
Press the transparent part into the black part.
Insert the other end of the wires into the modular plug.
Note
Do not peel off the wire coating. Insert the wires all the way.
b) Insert the 4-pin plug into a cell station jack on the unit, and attach the ferrite core
(included) to the plug cord.
D1
V1
V2
D2
D1
V1
V2
D2
1
2
4-pin plug Modular plug
Panasonic
6
1
CS
no.
D1
V1
V2
D2
2
3
4
5
CS INF
DIGITAL SUPER HYBRID SYSTEM
6CS
Panasonic
CS INF
2
1
CS
no.
D1
V1
V2
D2
DECT
5 cm
To the Cell Station
To the Cell Station
Ferrite Core
Roll the cord once around
the ferrite core and close
the core.
Note: Put it in the cabinet
when closing the cabinet cover.
Connect the ground terminal to ground.
Note: If other expansion units are
installed, the frame ground connection
is required for only one unit.
KX-TD144 KX-TD146