Filter
Top Products
64 / Time savers for making calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
If you select a line before pressing the autodial button, the call
goes out on the line you have selected instead of the line that
is part of the autodialer programming.
For the M7100 telephone, an external autodialer can be
programmed only by using a line and not a line pool.
Using intercom as the line for Autodial
If you press as the line for an external autodial
number, you must include a valid line pool access code or a
destination code. If line pool access codes or destination codes
are changed, remember to reprogram autodial numbers.
Displays
Tip -
If you do not include a line selection in an autodial
number, the call uses your prime line (if you have one).
Continue to enter digits until the number is
complete. Press or BKSP
to
erase an incorrect digit. Press or
OK
when you are finished.
The memory allotted to autodial numbers in
your Norstar system is full.
While programming external Autodial, you
erased the button by pressing or
OK before entering any digits.
Enter the number you want to program
(choosing the line first if necessary) exactly
as if you were making a call.
Enter the internal telephone number you
want to program.
987___
QUIT BKSP OK
Autodial full
Button erased
Enter digits
QUIT OK
Intercom
#
: ___
QUIT
p0881591.book Page 64 Wednesday, August 19, 1998 6:43 PM