Filter
Top Products
56 / Making calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
The Norstar Modular ICS system can have 15 line pools, and
a telephone can be programmed to access any number of them.
A line pool access code is a number you dial to get a line pool.
The access code can be up to four digits long. You can have
several different line pools for your system, each one giving
you access to a different set of external lines. It is one way of
sharing lines across telephones in a system.
Your installer or customer service representative programs the
line pool access codes and gives each telephone access to a
line pool.
Everyone in the office should have a list of the line pool access
codes for the line pools their telephones can use.
Using a line pool to make a call
1. Press .
2. Enter a line pool access code.
If you have a free internal line, you can make a call using a line
pool without entering the feature code first.
1. Select an internal line (intercom).
2. Dial the line pool access code.
Programming a memory button with a line pool feature code
When you program a button with the line pool feature code,
you must enter a line pool access code after the feature code.
Tip -
If no lines are available in the line pool, you can use
Ring Again at the busy tone. You are notified when a line
in the line pool becomes available. See “Using Ring
Again” on page 60.
p0881591.book Page 56 Wednesday, August 19, 1998 6:43 PM