Filter
Top Products
Programming Hunt Groups / 143
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press . The display shows Member DNs:.
9. Press until the display shows If busy:.
10. Press CHANGE to set the mode: BusyTone, Overflow,
Queue.
11. Press to exit or to continue programming.
Programming the queue time-out
This setting allows you to program the number of seconds a
call remains in the Hunt Group queue before it is routed to the
overflow position.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press (CONFIG).
The display shows Password:.
3. Press (SCPLUS). The display shows
Terminals&Sets.
4. Press until the display shows System
prgrming.
5. Press . The display shows Hunt groups.
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press . The display shows Member DNs:.
9. Press until the display shows Q Timeout:.
10. Press CHANGE
to set the queue time-out: 15, 30, 45, 60,
120, 180.
11. Press to exit or to continue programming.
p0881591.book Page 143 Wednesday, August 19, 1998 6:43 PM