Filter
Top Products
Programming Hunt Groups / 139
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press (CONFIG).
The display shows Password:.
3. Press (SCPLUS). The display shows
Terminals&Sets.
4. Press until the display shows System
prgrming.
5. Press . The display shows Hunt groups.
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press . The display shows Member DNs:.
9. Press . The display shows Line assignment.
10. Press . The display shows Show line:.
11. Enter the line number you want to program and press SCAN
to go to the first line assigned to this group, or press LIST
to go to the first line in the system.
12. Press CHANGE
to program the line as Unassigned or
Assigned.
*HGnn* means the line is assigned to another Hunt Group.
13. Press to exit or to continue programming.
Setting the distribution mode
There are three modes of call distribution:
• Broadcast—rings each set in the group simultaneously.
Calls are handled one at a time; other calls are queued. As
soon as a call is picked up, the call next in the queue is
presented to the Hunt Group without having to wait for
queue time-out.
p0881591.book Page 139 Wednesday, August 19, 1998 6:43 PM