Filter
Top Products
Programming Hunt Groups / 141
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
3. Press (SCPLUS). The display shows
Terminals&Sets.
4. Press until the display shows System
prgrming.
5. Press . The display shows Hunt groups.
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press . The display shows Member DNs:.
9. Press until the display shows Mode.
10. Press CHANGE
to set the mode: Sequential, Rotary,
Broadcast.
11. Press to exit or to continue programming.
Setting the hunt delay
This setting allows you to program the number of rings the
system permits at a Hunt Group set before moving on to the
next set in the Hunt Group.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press (CONFIG).
The display shows Password:.
3. Press (SCPLUS). The display shows
Terminals&Sets.
4. Press until the display shows System
prgrming.
5. Press . The display shows Hunt groups.
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
p0881591.book Page 141 Wednesday, August 19, 1998 6:43 PM