Filter
Top Products
Using System features / 189
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Displays
Programming Automatic Time and Date
You can program your Norstar system with the Automatic Time
and Date feature to automatically update the time and date.
Whenever the clock is out of sync by more than two minutes, as
a result of a power failure or a loss of power, the first incoming
call updates the clock automatically after two rings.
Note: CLASS Trunks are required for this feature to work.
Consult your customer service representative to
determine if you have CLASS Trunks.
This feature also allows the automatic changing between North
American daylight savings and standard time. Your system uses
the time and date information from the first incoming call after
two rings to update to daylight savings or standard time.
The Automatic Time and Date feature automatically overrides
any manually programmed changes to the time and date in your
system.
Note: The year is not included with the time and date
information and must be programmed manually if the
current year differs from the network time.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press (CONFIG).
The display shows Password:.
(Blank display) Enter your password. It is not
shown on the display.
You have entered a password that is not
programmed into your system.
Invalid Password
p0881591.book Page 189 Wednesday, August 19, 1998 6:43 PM