Filter
Top Products
Programming Hunt Groups / 137
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Norstar set can be in more than one Hunt Group but is
considered a member in each Hunt Group, increasing the total
number of members in the system.
There can be only one appearance of the same Hunt Group on
a set. Hunt Group DNs cannot be members of other Hunt
Groups. A DN can be associated with a member of a Hunt
Group and is called a member DN.
Consult your customer service representative to determine
your Hunt Group number range.
1. Place the programming overlay on any M7310 or M7324
telephone.
2. Press (CONFIG).
The display shows Password:.
3. Press (SCPLUS). The display shows
Terminals&Sets.
4. Press until the display shows System
prgrming.
5. Press . The display shows Hunt groups.
6. Press . The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press . The display shows Member DNs:. (There
are no member DNs if none are programmed.)
9. Press . The display shows the members for that
group.
10. Press ADD
to add a member or press REMOVE to remove a
member from the group.
11. Press to exit or to continue programming.
p0881591.book Page 137 Wednesday, August 19, 1998 6:43 PM