Filter
Top Products
130 / User Preferences
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
Use the display buttons to change the programming for a
button. User Preferences programming cannot change the
buttons that are used by lines, intercom, and the handsfree
feature.
The display buttons used in button programming.
Information about individual displays is described on page
132.
Changing User Speed Dial
1. Press at User Speed Dial. The display shows
the number of speed dial codes that are available.
2. Press to see the first speed dial code (71).
3. Press to move through all the speed dial codes.
4. Press at the code you want to change.
5. Press CHANGE
and enter the telephone number the same
way you would dial it on the telephone.
6. Press OK
.
CANCL
Moves you out of a setting without making any changes to it.
CLR
Erases the button.
TEL#
Programs the key as an autodial number for an internal or an
external number. If it is an external autodial number, you
must choose a line, line pool, or the routing table for the call
to use.
CHANGE
Used when you are setting up an external autodial number.
Press CHANGE
until you see the type of line or pool you want
the number to use.
FEATR
Press to store a feature code on the button.
FIND
Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
LIST
Takes you to a list of feature codes. Press to move
through the list and press OK
when you see the feature you
want to program on the button.
p0881591.book Page 130 Wednesday, August 19, 1998 6:43 PM