Filter
Top Products
18-3
Catalyst 2950 Desktop Switch Software Configuration Guide
78-11380-05
Chapter 18 Configuring UDLD
Configuring UDLD
Configuring UDLD
This section describes how to configure UDLD on your switch. It contains this configuration
information:
• Default UDLD Configuration, page 18-3
• Enabling UDLD Globally, page 18-4
• Enabling UDLD on an Interface, page 18-4
• Resetting an Interface Shut Down by UDLD, page 18-5
Default UDLD Configuration
Table 18-1 shows the default UDLD configuration.
A UDLD-capable interface also cannot detect a unidirectional link if it is connected to a
UDLD-incapable port of another switch.
Table 18-1 Default UDLD Configuration
Feature Default Setting
UDLD global enable state Globally disabled
UDLD per-interface enable state for fiber-optic media Disabled on all Ethernet fiber-optic interfaces
UDLD per-interface enable state for twisted-pair (copper)
media
Disabled on all Ethernet 10/100 and 1000BASE-TX
interfaces
UDLD aggressive mode Disabled