Filter
Top Products
Section 5 TutorialSection 5 Tutorial
3. Select the drive and directory where the setup file is located, then select the file and
choose OK. Some setup files are supplied for various mills and lathes. If a setup file is
not available for your machine, select LCXXX.STP, where “XXX” is the current
software version (eg. “LC141.STP” for version 1.21). Note that LCXXX.STP is
based on the Sherline 5400, but is easily modified to accommodate any machine tool.
4. Go through the Setup menus as described in Section 3, Initial Setup. Enter the values
that best describe your machine.
5. Choose All Coordinates from the View menu to make sure all four coordinate systems
are displayed.
Loading a G-Code File
1. Choose Open G-Code from the File menu.
2. Go to the directory where LC is installed and double-click on the file TUTOR.AGC.
The G-Code File TUTOR.AGC will now be loaded into LC and the screen should now
look like this: