Filter
Top Products
Section Section 33 Initial SetupInitial Setup
3737
4. Choose Before or After from the Before/After Move pull-down menu. If
you choose Before and there is a machine tool move command on the
same program line as the M-Code, the M-code will be executed before the
move. If you chose After, the M-code will be executed after the move.
5. In the Delay text box, enter the amount of delay between execution of the
M-Code and execution of the next G-Code command. For example, if
your spindle motor takes about 3 seconds to get to full speed, this value
should be at least 3. For safety reasons, the maximum value for this delay
is 5 seconds.
Motor Signal Settings
Anaheim Automation’s LC software provides four signals for step motor drivers:
step, direction, park and enable. Different manufacturers have different
requirements for the polarity and timing of these signals. The LC software
provides the flexibility to tailor the motor signals to run most drivers.
4 To Configure the Motor Signal Lines
1. Choose Motor Signals from the Setup menu. The Motor Signals Setup
dialog box will appear.
2. From the Step Pulse pull-down menu choose either High or Low
depending on the polarity of the step pulse. See the diagram below.