Filter
Top Products
Section Section 44 System ProgrammingSystem Programming
5151
+X
+Y
G02 Clockwise
+X
+Z
G02 Clockwise
+Y
+Z
G02 Clockwise
G03 Counter Clockwise Circular Cutting Move
The G03 command is identical to the G02 command, but it moves the tool in a
counter clockwise arc instead of a clockwise arc.
Example:
G01 X2.0 Y1.0 F8.0 Moves the tool directly to the Program
Coordinates X=2.0, Y=1.0 at a feedrate of
8.0 in/min.
G03 X0.0 Y3.0 I-1.0 J1.0 Moves the tool using counter-clockwise
circular interpolation to the Program
Coordinates X=0.0, Y=3.0 with a center
point of X=1.0, Y=2.0 at a feedrate of 8.0
in/min.
2,1 Start
1,2 Center
0,3 End