Filter
Top Products
Section Section 22 Main Screen FeaturesMain Screen Features
88
Port, and displays the program in the Program Listing Box. By default, the dialog
box displays files with an “.AGC” extension.
Close G-Code – Closes the open G-Code file.
Editor - Opens the editor dialog box and displays the current G-Code file. Using
this feature you can directly edit any G-Code file without leaving Anaheim
Automation’s LC software. Note that you can also double-click the Program
Listing Box to open the editor.
Open Setup - Opens a file containing all CNC Setup Parameters for your
machine tool. You can set these parameters using commands in the Setup and
View menus described below. Setup file names have a “.STP” extension by
default.
Save Setup - Saves the current CNC setup parameters under any file name in any
directory.
Save Setup As - Prompts you for a file name in which to save the current CNC
Setup Parameters.
Import DXF - Directly translates a 2-dimensional DXF file into G-Code for use in
Anaheim Automation’s LC software.
Exit - Closes the communications port to the controller, then exits the program.
This does not automatically turn off the controller. You must turn off the
controller separately.
Setup Menu
Machine Tool, Feedrate/Ramping, Tooling, Input Lines, Output Lines, Motor
Signals, G/M Codes, Import, System Options - Open dialog boxes where you’ll
enter your CNC setup parameters, such as the size of your machine tool envelope
or the configuration of your LC Controller. These parameters are described in
detail later in the manual.