Filter
Top Products
Section Section 33 Initial SetupInitial Setup
3939
2. Check the Ignore G54 checkbox if you want the LC to ignore this
command in a G-Code program. The LC does not currently support G54.
If you choose to ignore G54, make certain any G-Code program you run
does not rely on G54 to position the machine tool.
3. Check the Message on M00 Program Pause checkbox if you want the LC
to display a message dialog whenever it encounters an M00 command in a
G-Code program. If you uncheck this option, LC will pause processing of
the G-Code program without displaying a message.