Filter
Top Products
Section Section 44 System ProgrammingSystem Programming
5757
The first tool used in the program is tool #1, so it is selected in the Current Tool
pull-down menu on the main screen. The tool change position is defined as
Machine Coordinates X=2, Y=2, Z=0. Tool #1 is loaded in the machine tool.
Program zero has been set using tool #1. Program zero is set at Machine
Coordinates X=0, Y=0, Z=-4. The machine tool is moved to Program
Coordinates X=0, Y=0, Z=1 before the G-Code file is run.
G00 Z.25 Move the Z axis down to Program
Coordinates X=0, Y=0, Z=0.25, Machine
Coordinates X=0, Y=0, Z=-3.75
G01 Z-1.0 F10 Move the Z axis down to Program
Coordinates X=0, Y=0, Z=-1, Machine
Coordinates X=0, Y=0, Z=-5
G00 Z.25 Move the Z axis up to Program Coordinates
X=0, Y=0, Z=0.25, Machine Coordinates
X=0, Y=0, Z=-3.75
G28 Move the Z axis up and the X and Y axes
across to the Tool Change Position, Program
Coordinates X=2, Y=2, Z=4, Machine
Coordinates X=2, Y=2, Z=0
M06 T2 Change the tool to Tool #2. All coordinates
remain unchanged.
G43 H2 Apply the tool length compensation for tool
#2. The offset amount is 0.750 (2.250-
1.500). The tool does not move. However,
the Program Coordinates change to X=2,
Y=2, Z=3.25. The Machine Coordinates
remain unchanged at X=2, Y=2, Z=0.
G29 X1 Y1 Z0.25 Move the X and Y axes across and the Z
axis down to Program Coordinates X=1,
Y=1, Z=0.25, Machine Coordinates X=1,
Y=1, Z=-3.0
G01 X3 Y3 Z-1 F20 Linear interpolation to Program Coordinates
X=3, Y=3, Z=-1, Machine Coordinates X=3,
Y=3, Z=-4.25
G28 Z0 Rapid move in the Z axis only to Program
Coordinates X=3, Y=3, Z=3.25, Machine
Coordinates X=3, Y=3, Z=0
M06 T3 Change the tool to tool #3. All coordinates
remain unchanged.
G43 H3 Apply the tool length compensation for tool
#3. The offset amount is –1.250 (1.000-
2.250). The tool does not move. However,
the Program Coordinates change to X=3,