Filter
Top Products
Section Section 22 Main Screen FeaturesMain Screen Features
1818
program had been stopped in the middle of a G-Code line, choosing the
Start button will begin execution exactly where the program stopped.
Note that all moves begin with ramping when necessary.
Feed Hold Button - Stops execution of the G-Code file. Note that once the
Feed Hold button has been hit, the machine tool will always ramp down to
a stop if necessary to avoid loosing steps. For this reason, the slower the
ramp rate, the longer it will take from the time the Feed Hold button is hit
to the time the tool comes to a complete stop. You can also stop program
execution by hitting any key on the keyboard (except Shift or Ctrl) during
machine operation.
Jog Mode
Jog mode provides controls for manually positioning the machine tool in all three
axes.
Axis Jog Buttons
You can move a single axis of your machine tool by pressing and holding an Axis
Jog Button. Ramping is used if the current jog rate is faster than the maximum
unramped feedrate for a given axis. Note that you can also jog the machine using
the keyboard. The controls are mapped as follows:
X+ Ctrl + Right Arrow Key
X- Ctrl + Left Arrow Key
Y+ Ctrl + Up Arrow Key
Y- Ctrl + Down Arrow Key
Z+ Ctrl + Page Up Key
Z- Ctrl + Page Down Key
Jog Mode
Single Step - Sets the mode in which the tool will move exactly one motor
step each time an Axis Jog Button is chosen.
Slow - Sets the jog rate to the slow jog rate specified in the
Feedrate/Ramping Setup dialog box.
Axis Jog
Buttons
Jog Mode