Filter
Top Products
Section Section 44 System ProgrammingSystem Programming
4949
G01 Linear Interpolated Cutting Move
The G01 command moves the tool to the designated XYZ Program coordinate at
the designated feedrate using 3-Axis linear interpolation.
Example:
G01 X2.0 Y1.0 Z-1.5 F2.0 Moves the tool directly to the Program
coordinate X=2.0, Y=1.0, Z=-1.5 at a
feedrate of 2.0 in/min.
You do not need to specify all three coordinates, only the ones for which you
want movement.
Example:
G01 X4.0 Y3.0 Moves the tool to Program coordinate
X=4.0, Y=3.0, leaving the Z position
unchanged.
When using G01, there are several things to keep in mind:
• As explained for the G00 Command, X,Y, and Z are not required.
• The command is modal, i.e. G01 is in effect until another move
command occurs (G00, G02, or G03).
• The interpretation of the coordinates depends on the G90/G91
command in effect.
• The F command is used to designate a feedrate. The feedrate set with
the F command is modal (stays in effect until another F command
occurs).
Example:
G01 X4.0 Y3.0 Z1.0 F7.0 Moves the tool to Program coordinate
X=4.0, Y=3.0, Z=1.0 at a feedrate of 7.0
in/min.
X2.0 Y2.5 Moves the tool to Program Coordinate
X=2.0 Y=2.5, leaving the Z axis unchanged
at Z=1.0. The feedrate remains 7.0 in/min.
G02 Clockwise Circular Cutting Move
The G02 command moves the tool in a clockwise path from the starting point (the
current tool position) to the designated ending point in the currently selected plane
(see G17-G19). The I , J, and K parameters represent the relative X, Y, and Z
distances (respectively) from the starting point of the arc to the center point of the
arc.
Example: