Filter
Top Products
Section Section 11 Getting StartedGetting Started
11
1. Getting Started
Thank You
Thank you for purchasing Anaheim Automation’s LC controls, the affordable,
powerful CNC control system for Windows
. No other CNC system is easier to
set up and use than the LC. We’re sure you’ll enjoy easy to use menus and real
time graphics as you quickly and accurately cut parts on your machine tool.
We are committed to the excellence of the LC controls. Feel free to call us with
any comments or questions.
Product Support
We are committed to full support of the LC controller product line. There are
three support options:
Phone: (714) 992-6990 8:00 AM-5:00 PM, Pac. Time, M-F
Fax: (714) 992-0471 24 hours a day, 7 days a week.
E-mail: support@anaheimautomation.com 24 hours a day, 7 days a week.
Web Site: www.anaheimautomation.com 24 hours a day, 7 days a week.
System Requirements
• IBM PC or 100% compatible with a 66MHz or faster 80486DX, Pentium, or
higher CPU.
• At least 8MB of RAM.
• Hard drive with at least 20MB of space available.
• 3.5 inch, 1.44-MB floppy disk drives.
• VGA, SVGA or compatible video monitor.
• A Microsoft-compatible mouse. Note that for best performance, the mouse
should connect directly to the bus (the standard mouse plug on most systems),
or through a mouse bus port rather than through a serial port.
• One available RS-232 serial port. If the port has a 25-pin connector, a 9-pin
male to 25-pin female adapter will be required.
• Microsoft Windows 95, 98 or NT or Microsoft or PC DOS version 3.1 or later
running Microsoft Windows version 3.1 or 3.11.
Section