Filter
Top Products
System & Station
Program 10-4 – ACD/ISDN/Tandem Parameters
Strata DK Programming 5/00 3-41
System & Station
Table 3-1 DTMF Buffers
Important! The ports used for buffer memory are not available for telephones. The ports are
automatically assigned from the highest numbered port down, for the number of
ports used. Example, if four ports are needed as buffers in an RCTUC/D, then ports
239, 238, 237 and 236 will not be viable for telephones.
The first port that uses memory for this feature, by processor:
DK40i = 027
RCTUA = 032
RCTUBA/BB, B1CU = 079
RCTUC/D, B2CAU/BU, B3CAU/BU = 239
RCTUE/F, B5CAU/BU = 335
To assign a TR/LCR class of service to Tie lines receiving the incoming call, the Tie lines must be
placed in a CO line group in Program 16. Each Tie line can be assigned to different groups but an
individual Tie line can only be assigned to one group.
Once a Tie line is assigned to a line group in Program 16, it must be assigned a class of service in
the appropriate programs: 30, 40, 41, 43, 48 and 56. In these programs, ports 900~916 must match
the appropriate Tie line group number 01~16, respectively.
Example: Program 48-901#100, is the Program 48 assignment for all Tie lines in trunk group 01.
DTMF/
Buffers
LED 19 LED 18 LED 17
0 Off Off Off
4OffOffOn
8OffOnOff
12 Off Off On
16 On Off Off
20 On On On
24 On On Off
Note LEDs 19,18 17 Off disables the
feature.
Port Number Program 16 Line Group Number
900 00
901 01
.
.
.
.
.
.
916 16