Filter
Top Products
ISDN
Guidelines for Programming ISDN Calling Features
7-8 Strata DK Programming 5/00
Programming for ISDN PRI DNIS Type Call
The following table shows the minimum programming needed to make DNIS-type ISDN PRI calls
work in the Strata DK System.
Table 7-3 ISDN PRI DNIS Type Call Programming
Program
Number
Program Data Description
03 XX 79 XX equals the slot in the DK system where the RPTU PCB is placed.
10-4 LED 9 On
LDN registration will route the unknown number or call type in numbering
plan.
*
16 XX 2 This tells the system that trunk group XX is an ISDN PRI trunk group.
*
42 1 XX 1
This tells the system to make the ISDN PRI Span the span the primary
clocking source for the DK System. “XX” stands for the DK slot where the
RPTU PCB is placed, and the final “1” refers to circuit 1.
*
43 1 1 24
This tells the system that the D-Channel on the 1st ISDN PRI Span is the
24th channel on the PRI Span.
*
63 2 04
This tells the system how long to wait to collect digits from station users
making a ISDN PRI call before sending it to the network.
*
64-1 1 LED 01 On
This tells the system to except the incoming calls on the PRI Span as DID or
DNIS calls.
*
64-2 X “X” tells the system the number of digits to look for on a DID or DNIS call.
*
65-1 CO LED 001-023 On
This tells the system that there are 23 bearer channels on the first Channel
Group and that they will appear on CO lines 001~023.
*
66-1 1 01 1
This tells the system that Trunk Group 01 is assigned to PRI Channel Group
(1).
*
66-3
01 LEDs 01-02, 11-12
On
This tells the system that Operator calls, Carrier Access, 1+10 Digit Dialing,
and Ring Back Tone to the outside caller are allowed.
01 LED 13 On
This tells the system when interfaced with DMS XXX to send the Progress
Descriptor 81 or 83.
LED 14 On When connecting to a DMS XXX with NI1 protocol.
LED 15 On
Set up message for outgoing call. When connecting to a DMS XXX. LED 11
must be Off in Program *66-3 when this LED is On.
*
66-5 1 01 XXXX
This assigns the LDN/DID/DNIS number, the Q (asterisk) can be used as a
wildcard.
*
66-6 1 01 LEDs 01~23 On This assigns the CO lines to the index.
*
67-1 01 3 This tells the system that the PRI Span is for both way calling.
*
67-2 01 LEDs 01-04 On
This tells the system to accept Speech, 3.1K Analog, 56K, and 64K type calls
on the ISDN PRI Span.
*68-1 1 01 LEDs 01-03 On
This tells the system to accept and send Calling Party Number on ISDN PRI
calls.
*
68-2 01 XXX-XXX-XXXX
XXX-XXX-XXXX is the number you want the system to send out on an
outbound call for Caller Number Identification.
*
69-1 000-344 1 00
This tells the system to send the number entered in Program 68-2, as the
Calling Party Number Identification for all station on outbound calls.
17
001- 023 LEDs 03~08
On
This tells the system to accept DNIS calls on the ISDN PRI trunks 001~023
and to following DNIS Program 71 - 72, and show ANI if presented to the DK
system.
71-0 000 XXXX
This tells the system that the incoming DNIS number XXXX is assigned to
DNIS address 000 in the DK system.