Filter
Top Products
When connecting an Ethernet cable
Connect the Ethernet cable as shown in the following figures.
• If the distance from the end of the connector to the bend in the cable is 30 mm (1
3
/16 in) or less
30 mm (1
3
/
16 in)
or less
Ethernet cable
• If the distance from the end of the connector to the bend in the cable is more than 30 mm (1
3
/16 in)
Remove the cable cover (A) from the back of the stand, and then run the Ethernet cable so the stand lies
flat on a horizontal surface.
A
Ethernet cable
98 Operating Instructions Document Version 2011-09
Connections and Installation