Filter
Top Products
Troubleshooting
6-6 Appendix
Problem Remedy
You cannot store a phone number
and name in the directory.
The alarm sounds after pressing the
Redial button.
“ ” flashes or beeps tones sound
every 5 seconds during a
conversation.
You charged the batteries fully,
but “ ” flashes.
The PS stops working during
operation.
Handover does not work.
The display does not show a strong
radio signal “ ” even though you
are near the CS.
The alarm sounds during a
conversation while receiving a weak
radio signal
“”.
• Your entry exceeds the maximum digits or characters.
• Do not pause for over 30 seconds while programming.
• A number is not saved in the Call Log.
• The battery is low.
➡ Charge the batteries fully. (☞ P. 5-5)
➡ Clean the charge contacts and charge again.
➡ It is time to change the batteries. Please purchase new
batteries.
➡ Turn the power switch OFF and ON. Then try again.
(☞ P. 5-7)
➡ Re-insert the battery and try again. (☞ P. 5-5)
• You moved to a busy CS or are out of range.
• You moved while not having a conversation (e.g., while
hearing a busy tone).
• The radio channel is busy or a radio communication error
occurred.
• Normally, the PS user can make a call even with a “ ”
status. In this case, the current linked CS is still connected
even though another CS is closer.
• The radio signal is weak.
➡ Move closer to the CS.