Filter
Top Products
Appendix 6-5
Appendix
Problem Remedy
The PS does not work.
The PS does not operate.
The PS does not ring.
You cannot dial.
Static, sound cuts in/out, fades.
Interference from other electrical
units.
“CS Busy” is displayed.
“FAULT” is displayed.
“PS NO CONNECTED” is displayed.
“REGISTER UNIT” is displayed.
“NO SERVICE” is displayed.
• The battery is empty.
➡ Charge the batteries fully. (☞ P. 5-5)
• The PS has been cancelled or the PS has not been
registered.
➡ Consult your dealer.
• The power switch is OFF.
➡ Turn it ON. (☞ P. 5-7)
• Ringer volume is set to OFF or VIBRATION.
➡ Set to ring by pressing the Volume Control button.
(☞ P. 5-7)
• The PS is out of range or the Cell Station (CS) is busy.
➡ Move closer to the CS or try again later.
• The radio channel is busy or a radio communication error
occurred.
➡ Try again later.
• The number which you dialled is restricted by the system.
➡ Consult your dealer.
• The key lock mode is set.
➡ To cancel the mode, press the Function for about 2
seconds. (☞ P. 5-25)
• The radio channel is busy or a radio communication error
occurred.
➡ Try again later.
➡ Set the PS and CS away from other electrical appliances.
➡ Move closer to the CS.
• The radio channel is busy.
➡ Try again later.
➡ Consult your dealer.
• The power switch is set to OFF.
➡ Turn it ON. (☞ P. 5-7)
• The PS is out of range.
➡ Move closer to the CS.
• The radio channel is busy or a radio communication error
occurred.
➡ Try again later.
• The PS is not registered in the system.
➡ Consult your dealer.
• The PS is out of range.
➡ Move closer to the CS.
Troubleshooting for DECT Portable Station