Filter
Top Products
Customising Your Phone & System 4-9
Customising
Display
The display gives you useful messages about programming. The multiple-line display also shows the
available functions. Follow the message at each step. This is a display sample in the initial
programming mode.
The message line guides you through programming and lets you confirm your selection. For example,
when “Jack No? →” is displayed, enter the jack number. The display shows up to 16 characters at a
time. To scroll the display, press → or ←. The function line shows you the function of the Soft button
located below it. When the SHIFT button light beside the display is on, subtitles are available.
Press the SHIFT button to confirm the available functions.
Jack Number / Extension Number
Certain programming is assigned to each jack number. The jack number is where your telephone
connects to the system. If two telephones share one jack and have their own extension number (eXtra
Device Port [XDP]), the jack number is determined as Jack XX-1 for a proprietary telephone and Jack
XX-2 for a single line telephone. The display may show XX-2, even if an extension has not set XDP.
If you do not know the jack number or extension number, check it as shown below.
Confirmation
To confirm your entry after storing data;
• The STORE button light: Lights red.
• Confirmation Tone:
– One beep: Your entry is accepted.
– Three beeps: Your entry is rejected.
Message Line
Function Line
Multiple line type
(The last two lines)
Soft buttons
One line type
USR-PGM NO?→ USR-PGM NO?→
CLR NEXT
SHIFT
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
After confirmingIf you do not know the jack / extension number
9 6
9
Dial 996.
OR
PAUSE
PROGRAM
OR
PAUSE
PROGRAM
END
Press END.