Filter
Top Products
Operation 2-5
Operation
When You Use a Panasonic Proprietary Telephone
If you use a Panasonic proprietary telephone and the Console, they may have some of the useful
function buttons listed below. These buttons make operations simple. The illustrations may differ from
the buttons on your telephone.
AUTO ANSWER
MUTE
AUTO ANSWER / MUTE: Used to receive
an incoming intercom call in the hands-
free mode or mute the microphone during
a conversation.
ANSWER: Used to answer an incoming
call.
AUTO DIAL
STORE
AUTO DIAL / STORE: Used for System
Speed Dialling or storing program
changes.
(CO)
CO: Used to make or receive an outside
call. A Loop-CO button supports all lines.
Pressing this button seizes an idle line
automatically. (Button assignment is
required.)
Also used as the desired function
buttons.
(Button assignment is required.)
(Only the CO “number” (e.g. 1, 2) may be
shown on some telephones.)
CONF
Conference: Used to establish a three-
party conversation.
FLASH / RCL
FLASH / RCL: Used to send a flash
signal to the Central Office or another
connected PBX. Or used to disconnect
the current call and make another call
without hanging up.
FWD/DND
Function: Located beside the display.
Used to perform the displayed function or
operation.
Call Forwarding / Do Not Disturb:
Used to perform Call Forwarding or Do
Not Disturb.
Jog Dial: Used to adjust the volume and
the display contrast or select desired items
for each function.
HOLD
HOLD: Used to place a call on hold.
INTERCOM
INTERCOM: Used to make or receive an
intercom call.
MESSAGE
MESSAGE: Used to leave a message
waiting indication or call back the party
who left the message waiting indication.
MONITOR
MONITOR: Used for hands-free dialling.
You can monitor the party’s voice hands-
free.
PAUSE
PROGRAM
PAUSE: Used to insert a pause during
dialling. Used to enter the programming
mode instead of using the PROGRAM
button.
(PF)
PROGRAM: Used to enter and exit the
Programming mode.
Programmable Function: Located on the
upper part of the CO button or on the DSS
Console. Assigns the desired button and
used to access the stored function. Mostly
used as a one-touch dialling button.
(Only the
“F and number” may be shown on
some telephones.)
REDIAL
(SAVE)
REDIAL: Used to redial.
RELEASE
RELEASE: Used to disconnect the line.
SAVE: Used to store a dialled phone
number and redial.
(DSS)
DSS: Used to access the extension.
(Only the
“S” may be shown on some
telephones.)
ANSWER
MODE
MODE: Used to shift the display to access
various features.